Rifle and Handgun Die Sets - Series B Die Set For Straight Wall Cases. Full length die sets for bottleneck cases contain two dies. The full length (FL) resizing die contains a decapping rod assembly with a neck expander (size button). The seating die (ST) includes bullet guide, built-in crimp ring and the proper seating plug.
Full length resizing while maintaining exact control of the case neck is often desirable in one operation. The new Type S - Full Length Resizing/Bushing Die accomplishes this task with the precision you would expect from Redding. Uses the same interchangeable bushings (.001" increments) as those used in our bushing style neck sizing dies. The adjustable decapping rod allows you to adjust the bushing position, sizing only part of the neck length when desired. Concentricity is enhanced by the ability of the bushing to self-center on the neck of the cartridge case. All Type S (except 17 and 20 Cal.) dies are supplied with both the standard size button and a decapping pin retainer for the advantages and versatility described under our Type S - Bushing Style Neck Sizing Dies. Note: By removing the bushing and all internal parts, the Type-S full bushing die may also be used as a body die. All dies are supplied without bushings. Contains Type S – Bushing Full Sizing Die and Competition Seating Die.
Eliminates handling of primers during sizing, and speeds-up reloading operations. Comes complete with individualized tubes for both large and small primers. Capacity: approximately 100 primers. Fits the T-7 and Big Boss Presses.